Core drilling in concrete: performance, stand and safety

Core drilling in concrete: performance, stand and safety

A core drill does not drill the entire hole for dust – the diamond core only cuts a thin ring and leaves a cylinder (core) in the middle. Thanks to this, you can make a clean hole for waste, a hood, heat recovery or a protector even in reinforced concrete.

Power and average

The larger the diameter of the core bit, the more power and lower the speed the machine needs. When choosing, pay attention to the maximum diameter specified by the manufacturer (for example, 205, 255 or 305 mm) and the power reserve - drilling through the fitting will put a lot of strain on the machine.

On a stand or handheld

Larger diameters are drilled from a stand that is anchored to the wall or floor. The core bit goes straight, does not get stuck and the operator does not have to hold the machine in his hands. Only small diameters are drilled from the hand.

Wet drilling

Diamond core bits are cooled with water when working on concrete:

  • water cools the segments and extends their service life,
  • washes away sludge and reduces dust,
  • you need a water supply or pressure vessel and sludge collection.

Safety

  • Before drilling, check where electrical wiring and pipes run.
  • When drilling wet, use a socket with a residual current device .
  • Anchor the stand firmly – a loose stand is the most common cause of a stuck crown.
  • Consult a structural engineer when drilling into supporting structures.

Tip

Drill the first few millimeters slowly until the bit “finds” the groove. Then increase the feed, but don’t push – let the machine work. When the speed drops significantly, reduce the pressure.

← Späť na blog